BESTSELLING G305 lightweight | Hex Cut Body | Only 12g! | V2.34

Description

THIS PRODUCT IS ALWAYS A WORK IN PROGRESS. PURCHASES WILL ALWAYS HAVE THE MOST UP TO DATE DESIGN, MOST OF THESE CHANGES ARE TO IMPROVE USABILITY, REDUCE WEIGHT, AND IMPROVE YIELD BY MAKING THE ITEM EASIER TO MANUFACTURE.
PLEASE NOTE; Both white and black parts are printed in black or white resin. The black will show white scratches, this can be wiped away with simple water and a paper towel. The white printed parts will yellow over time if exposed to UV light (the sun). If your mouse is going to be located in any sunlight you will need to clear coat the parts to avoid them becoming more fragile and yellowing. Any spray paint will do.
When tightening screws make sure to not
over-tighten
as you will break the screw posts, 2 finger strength is all that is needed, enough to hold the PCB in place. Please install everything with the body on a flat HARD surface, do not try to install anything while holding the body in one hand while pushing something into place with the other hand.
NEW! CUSTOM MIXED RESIN TO REPLACE
ORIGINAL
BLACK!
Mixed in house with multiple different types of resin while still retaining that deep black color, the black resin is now much more flexible and will no longer be as brittle as an egg shell once properly cured.
Any orders from 2/20/2020 onward will ship with the new custom mixed resin.
The white is printed using ABS like resin from Elegoo.
If you are having problems with your scroll wheel middle click, there is a portion on the midsection that fits over the scroll wheel shaft and is supposed to sit on the right side of the spring on the scroll wheel. If that detente is installed directly on top of the spring the middle click will be hard to click down, i recommend installing the midsection by putting in the right side first at a 45 degree angle, making sure that detente isn't sitting on the spring (you wont be able to see it, slide it essentially). So the right half is pushed into the bottom shell first, then the left half. Loosening the underside screws 1 or 2 turns also relieves some pressure.
If you have having problems with your DPI button, check to make sure your wires are out of the way entirely of the plastic spring mechanism. If it refuses to push down correctly chances  are you have a wire where it isn't supposed to be.
G305 lightweight | Hex cut battery cover | Lower your G305 weight
SLA printed in resin, the replacement bottom section weighs only 14 grams, 6 grams less than the stock bottom section, while this may be a small amount of weight shaved, with other SLA printed parts you can easily reduce the weight of your G305 by up to 60 grams!
Check out my listings for a cheap rechargeable AA to AAA battery conversion kit for the G305 as well as other SLA printed parts to save weight now!
V2.34 - Beefed up the screw hole for side button PCB to prevent cracking
V2.20 - adjusted side button position
V2.19 - adjusted side button screw hole position
V2.07 - Screw hole alignment adjusted
V2.0 - Complete redesign from the ground up
Thinner walls to reduce weight
Hex cutouts in front and back lips
Beefed up screw holes to prevent cracking
V1.13 - Fixed underside screw holes
V1.0 -
Initial release
Side and bottom hex pattern inspired by - whuu on thingiverse
Blank scanned model - amphibiousParakeet on thingiverse
Non-Deliverable/Return To Sender Policy:
Every item that is returned to sender, either via insufficient address or otherwise is subject to a 20% restocking fee on the refund amount. Any package that is returned to sender or non deliverable will automatically be refunded with the restocking fee deducted from the refund.